Robe Robin LedBeam 150, Руководство пользователя

Страница: 15 / 32

15
5.4 Manual Control (Manual)
Use the menu to control all fixture channels by means of the control panel.
5.5 Test program (Test Prg)
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ROBIN LEDBeam 150.
Static - Static mode . This mode is suitable for projections on the wall, ceiling or ground
without any head movement.
Dynamic - Dynamic mode. This mode uses all ROBIN LEDBeam 150 functions including
pan/tilt movement and therefore is good for a complete introduction of the fixture.
5.6 Stand-alone (St Alone)
Music T - Music trigger . Select this function to enable the sound control of the running program via the built-in
microphone.
Auto Run
-
Presetting playback
. This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on. Selected program will be played continuously in a loop.
Off - The option disables „Auto Run” function.
Test - The option will start built-in test program.
Prog 1 - The option will start user-created program 1
Prog 2 - The option will start user-created program 2
Prog 3 - The option will start user-created program 3
Pr Play - Playing program . Select this menu to run a user-created program in a loop.
Test Prg - The option runs built-in test program.
Prog 1 - The option runs user-created program 1
Prog 2 - The option runs user-created program 2
Prog 3 - The option runs user-created program 3
Select the program you wish and press [ENTER]. The selected program starts running. By Pressing [ENTER]
again, program pauses running.
Pr Edit
-
Editing program
. Select this menu to edit or create the program. The ROBIN LEDBeam 150 has one
built-in program and one user-editable program up to 40 steps. Each program step has a step time - during
which effects last in the current step and a fade time- during which effects move to new positions.
To edit program:
Procedure:
1. Press [NEXT] or [PREV] to select the menu "Edit" and press [ENTER] .
2. Press [NEXT] or [PREV] to select the desired program step and press [ENTER] button.
3. Press [NEXT] or [PREV] to select the desired item and press [ENTER] button. Now you can edit by [NEXT]
or [PREV] buttons the DMX value (0-255) for selected item:
Prg End. a total number of the program steps (value 1-40). This value you should be set before
starting of programming (e.g. if you want to create program with the 10 steps,
set Prg End=10).
PAn a coarse pan movement
PAn F a fine pan movement
Tilt a coarse tilt movement
Tilt F a fine tilt movement
P/T Sp a pan/tilt speed
Powr power/special functions
Virt C a virtual colour wheel
Red a red colour coarse
Red F a red colour fine
Green a green colour coarse
Green F a green colour fine
Blue a blue colour coarse
Blue F a blue colour fine
White a white colour
White F a white colour fine
CTC a colour temperature correction