Robe Robin DLX SPOT, Руководство пользователя

Страница: 27 / 49

7
Static Gobo channel 39 channel 8 channel 6
Rot. Gobo Wheel channel 40 channel 9 channel 7
Rot. Gobo Index. channel 41 channel 30 channel 28
Prism channel 42 channel 31 channel 29
Iris channel 43 channel 32 channel 30
Zoom channel 44 channel 33 channel 31
Focus channel 45 channel 34 channel 32
Red channel 46 channel 35 channel 33
Green channel 47 channel 36 channel 34
Blue channel 48 channel 37 channel 35
White channel 49 channel 38 channel 36
Calibrate Driver - The function runs recalibration of the LED driver. It is suitable use this function when some
non-uniform colour changes appear during colour saturation or if software upgrade is executed.
Load Default Calibrations - The item loads default (factory) calibration values.
Updating software - The menu item allows you to update software in the fixture via either serial or USB port
of PC.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX No.13050624 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Note 1: Software update should execute a qualified person. If you lack qualification, do not attempt the updatey -
ourself and ask for help your ROBE distributor.
Note 2: DMX address, IP address, programs 1-3 and all items in the menu "Personality" will be set to their
default (factory) values.
To update software in the fixture:
I. Installation of the DMX Software Uploader.
1. DMX Software Uploader program is available from the ROBE web site at WWW.robe.cz.
2. Make a new directory ( e.g. Robe_Uploader) on your hard disk and download the software to it.
3. Unpack the program from the archive. If the Robe fixture is produced in both magnetic
and electronic ballast version, name of DMX Software Uploader is the same for both versions.
II.Fixture software updating.
1.Determine which of your ports is available on your PC and connect it:
- with the DMX input of the fixture if you using the flash cable RS232/DMX
- with the DMX output of the Robe Universal Interface if you using the USB cable.
Disconnect the fixture from the other fixtures in a DMX chain. Turn both the computer and
the fixture on. Make sure the lamp is switched off (only if the fixture involves a lamp).
2. Switch the fixture to the updating mode by touching the "Updating Software " item
Note: If you do not want to continue in software update, you have to switch off and on the fixture
to escape from this menu.
We recommend to cancel all running programs before starting the Software Uploader.
3. Run the Software Uploader program. Select desired COM and then click on the Connect button.
(Select COM if the serial port is used or DreamBox1 if the USB port is used).
If the connection is OK, click on the “Start Uploading button“ to start uploading. It will take several
minutes to perform software update.
If the option "Incremental Update" is not checked, all processors will be updated (including
processors with the same software version).
If you wish to update only later versions of processors, check the “Incremental Update box“.
Avoid interrupting the process. Update status is being displayed in the Info Box window.
When the update is finished, the line with the text “The fixture is successfully updated“ will appear in
this window and the fixture will reset with the new software.
After updating, the fixture, calibration of the LED driver may start (it depends on software version
before calibration). The calibration will last cca 5 minutes (time depends on LED module temperature),
do not interupt this process.