Robe Robin CycPix 12, Руководство пользователя

Страница: 20 / 29

CycPix 12
20
High Res - A maximum temperature of the the moving LED head since the counter
was last reset.
In order to reset this counter, press and hold both [UP] and [DOWN] buttons and the
[Enter] button at the same time.
Sw Ver - Software versions . Select this item to read version of software in fixture processors (IC-1, IC-2, IC-3,IC4,
WL).
6.3 Personality (Pers)
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 18 control channels
Mode 2 - 12 control channels
Mode 3 - 54 control channels
Mode 4 - 66 control channels
DMX In
- DMX input . Use the menu to select mode of receiving DMX signal.
Wired - DMX signal is received by means of the standard DMX cable.
Wireless - DMX signal is received by means of the inbuilt wireless module (if the module is installed).
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function rotates menu 180 degrees from current orientation.
On/Off T - This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast - Use this function to adjust contrast of the display (0-100%).
Backlight - Use this function to adjust backlight of the display (0-100%).
C Cal M - Colour calibration mode . If the functin is on, the white output (2700K-8000K) from the fixture (and also
mixed colours) is more uniform. Each colour is dynamically corrected according to the value set in the menu
"Calibrate Effects" (Special-> Adjust-> Calib).
C Mix M - Colour mixing mode . This item allows switching into RGBW or CMY mode. In the CMY mode, white
channels (8-bit and 16-bit) are not active.
Whi Cnt
–
White counting
. If this function is On, the white LED of each pixel lights when a white colour is mixed.
The light intensity of the white LED is in a proportion to the intensity of the rest of pixel´s LEDs (red, Green, blue)
and improves the white output of the pixel. The function influences “pixel modes” only - DMX mode 3 and 4
(RGBW colour mixing mode has to be set).
Dimer C – Dimmer curve . This menu item allows to set linear (Linear) or square law (SqL) dimmer curve.
Temp Uni - Temperature unit . Use the menu item to change temperature unit from °C to °F.
I Ef Pos - Init effect positions . Use the menu to set all effects to the desired positions at which they will stay after
switching the fixture on without DMX signal connected.
Defaults - The menu item allows to set all fixture parameters to the default (factory) values.
6.4 Manual Control (Manual)
Manual C - Manual control . Use the menu to control all fixture channels by means of the control panel. Displayed
menu items depend on selected DMX mode.