Robe ROBIN colorstrobe lite, Руководство пользователя

Страница: 9 / 50

9
Floor installation via the floor stand
1.
Fasten the floor stand (1) to the U-holder (2) of the fixture by means of two 1/4 turn locks (3).
2.
The tilt lock (7) allows to adjust the fixture to desired position.
Rigging the fixture via the omega holder
1. Bolt the clamp (1) to the omega holder (2) with M12 bolt and lock nut through the hole in the holder.
2. Fasten the omega holder to the U-holder (4) of the fixture by inserting both quick-lock fasteners (3) into
holes in the U-holder and tighten fully clockwise.
3. Clamp the fixture on a truss (12) and tighten the rigging clamp (1).
4. For securing the fixture to the truss, install a safety wire that can hold at least 10 times the weight
of the fixture. Use only a safety wire with a snap hook with screw lock gate. Pull the safety
wire (11) through the U-holder (4) and around the truss (12) as shown on the picture below.
5. The tilt lock (7) allows to adjust the fixture to desired position. In case, that the tilt lock cannot
be loosened (tightened) due to the housing of the fixture, pull this tilt lock in a direction from the fixture,
turn it to desired position, release it and continue in loosening (tightening) this tilt lock (principle of
a "ratcheting socket wrench").