Robe Faze 1000 FT, Руководство пользователя

Страница: 5 / 9

4 5
3. Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
Before beginning initial setup of your ROBE Fog Machine, make sure that there is no evident damage caused
by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt
to use it until after contacting your ROBE distributor for assistance.
4. Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed, espe-
cially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
Fill with only an original liquid recommended by ROBE distributor.
Other liquids may cause spitting and serious clogging problem and could result in the production of an unhe-
althful fog. The use of other liquids voids the warranty of the Faze 1000 FT. When filled, place cap back on
liquid tank.
Firmly attach the control module cable to the connector inside the rear chamber of the machine.
WARNING:
Use of any liquid other than original liquid recommended by ROBE distributor or modification or attempted to
unauthorized repair of the Faze 1000 FT will immediately invalidate the warranty.
5. Operation
The plug is positioned that the plug is accessible when used machine.
Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to "ON" position. Warm-up
is complete when the display on control module shows "Ready to Fog."
To emit fog, press the appropriate button on the control module for the desired length of time.
The control unit's display will cycle "Warming up" and "Ready to Fog" as the machine re-heats to the proper
operating temperature.
When the liquid is running low, the LED inside the tank chamber starts blinking for two minutes and then stop
operation to protect the pump from running dry..
Always monitor liquid level to prevent interrupted operation.
For further information on operating your Faze 1000 FT, see the section titled, "Control Module Operation"
on page 6.
Caution
: "Visibility during operation is reduced"
If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level
or suspended overhead. If the unit is to be mounted using the bracket, it is important that the fog does not
shoot directly at any one's face. Whatever installation method you choose, do not allow the unit to have more
than a 15 degree angle of inclination.
Important!
Always monitor tank liquid level as you are fogging.
Running a fog machine with no liquid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug immediately. Check liquid level, the exter-
nal fuse, control module connection, and power from the wall. If all of the above appears to be O.K., plug the
unit in again. If fog does not come out after holding the control module button down for 30 seconds, check the
hose attached to the tank to make sure there is liquid going through the hose. If you are unable to determine
the cause of the problem, do not simply continue pushing the control module button, as this may damage the
unit. Return the machine to your ROBE distributor immediately.