Robe Divine 60 UV, Руководство пользователя

Страница: 13 / 25

Divine 60 UV
13
IC3.L. --- LED processor 3
IC4.L. --- LED processor 4
ViFi --- Wireless DMX module (if installed)
tEMP --- Fixture Temperatures. Select this menu to read the temperatures of the fixture:
bASE
Cur.t. --- the current temperature of the fixture base.
Hi.tE. --- the menu item shows the max. temperatures of the fixture base since
the fixture has been fabricated.
rSEt --- the menu item shows the maximum temperatures of the fixture base since the counter
was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN
buttons and at the same time press the ENTER button.
LEdS
Cur.t. --- the current temperature of the fixture LEDs PCB.
Hi.tE. --- the menu item shows the max. temperatures of the LEDs PCB base since
the fixture has been fabricated.
rSEt --- the menu item shows the maximum temperatures of the LEDs PCB since the counter
was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN
buttons and at the same time press the ENTER button.
The temperatures can be displayed in either °C or °F units - see option “tnP.u.“ in the menu “Pers“.
DM.In. --- DMX values . Select this function to read DMX values of each channel received by the fixture.
5.3 Personality
Use this menu to modify the Divine 60 UV operating behaviour.
DM.Pr. --- DMX preset . Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
dM.In. --- DMX input . Select this menu item to select desired DMX input:
UirE --- Wired DMX.
UirL --- Wireless DMX
UrLo --- Wireless DMX –> wired DMX. The fixture receives wireless DMX signal and sends it to its
DMX output connector. Next fixtures can be connected to this fixture by DMX cable (fixture works
as a Wireless-DMX converter.
AnL.d. --- Analog dimmer. If this option is selected, the dimmer channel can be controlled via
DC voltage (0-10V) connected between pins 1 (data ground) and 3 (Data +) of DMX input of
the fixture (0-data ground, 10V-data +).
Procedure of setting:
1. Set fixture´s channels at desired values (by means of menu item Init Positions “In.Po”).
2. Disconnect DMX controller
3. Select option “AnL.d.” from menu DMX input
4. Connect DC voltage to the DMX input of the fixture
F.tin. --- Max. Fade time. Select this menu item to set a desired max. fade time (0-25.4 sec.). This adjusted fade
time influences fade of Red, Green, Blue,White and dimmer during DMX operation:
If time between two receiving DMX values is > than fade time set in the item “F.tin. “, the entire adjusted fade time
will be used.