Robe Color Spot 575AT, Руководство пользователя

Страница: 25 / 33

24 25
9.7 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ColorWash 575 AT.
Mod. 1
---
Mode 1
. This mode is suitable for projections on the wall, ceiling or ground
without any head movement.
Mod. 2
---
Mode 2.
This mode uses all ColorWash 575 AT functions including pan/tilt
movement and therefore is good for a complete introduction of the fixture.
9.8 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Audi
---
Music trigger
.Select this function to enable the sound control of the running programs via the built-in
microphone.
Auto
---
Presetting playback
.This function allows you to select the program which will be played in the stand-
alone mode after switching the fixture on.Selected program will be played continuously in a loop.
d.Abl
--- The option disables "Auto" function.
tESt --- The option will start built-in test program.
PrG. 1 --- The option will start created program No.1
PrG. 2 --- The option will start created program No. 2
PrG. 3 --- The option will start created program No. 3
Note: If the fixture operates in the controller mode ( DMX controller is connected) and any program from this
menu is selected ,in this case the fixture will not respond to the DMX controller after switching on and will play
selected program.
PLAY
---
Playing program
.Select this menu to run a bilt-in program or the 3 freely-programmable programs
in a loop.
tESt
--- The option starts built-in test program.
PrG.1
--- The option starts created program No. 1
PrG.2
--- The option starts created program No. 2
PrG. 2
--- The option starts created program No. 3
Select the program you wish and press [ENTER].The selected program starts running.By Pressing [ENTER]
again is possible to pause the program running.
Edit --- Editing program .Select this menu to edit or create the program.The ColorWash 575 AT has one built-
in program and the 3 free programs,each up to 99 steps.Each program step has a step time.Step time-the
time,during which effects last in the current step.
If the fixture is set as a master ,then you may edit any program in the slaves.You can't edit programs on the
slave fixtures from their control panels if the master fixture is switched on and connected to the slaves (editing
is possible by the master control panel only).
Procedure:
1. Press [UP] or [DOWN] to select the program you want to edit ("PrG.1" - "PrG.3") and press [ENTER].
2. Press [UP] or [DOWN] to select the desired fixture ("MASt." - "SLA.9") and press [ENTER]-button.
3. Press [UP] or [DOWN] to select the desired program step ("St.01" - "St.99") and press [ENTER]-button.
4 Press [UP] or [DOWN] to select the desired item and press [ENTER]-button.Now you can edit by [UP] or
[DOWN] buttons the DMX value (0-255) for selected item:
P.End. -
a total number of the program steps (value 1-99).
This value you must set before start
programming (e.g. if you want to create program with the 10 steps,set P.End=10).
PAn a coarse pan movement C.SPd. a CMY/CTC/dimmer speed
F.PAn a fine pan movement Macr. a CMY macros
tilt a coarse tilt movement EFFE. an effect wheel
F.tilt a fine tilt movement EF.ro. a beam shaper rotation
SpEd a pan/tilt speed Zoom a zoom