11
RC installation
1. Remove the structure
2. Insert the receiver and secure it against slipping with Velcro or a cable tie (see illustration).
Motor and battery connection (
see connection diagram p. 10)
1. Connect the speed controller to the motors.
2. provide the battery cables with one socket each.
3. Make a V-cable from the strand to connect the batteries to each other. Connect a plug to
the battery connection cable of the speed controller.
Dr
iving
:
Turn on the transmitter and connect the drive battery to the speed controller. Alternatively, you
can install an ON/OFF switch between the drive battery and the speed controller. The
mounting frame (A) for the ON/OFF switch is already glued on the starboard side under the
coaming.
Important notice:
Switch on:
Always switch on the transmitter first, then connect the speed controller to the drive
battery!
Switch off:
Always disconnect the speed controller from the drive battery first, then switch off
the transmitter!
Always observe the safety instructions and notes on driving on pages 5 and 6!
3. Place the remaining RC components such as the speed controller and drive battery in the
fuselage.
4. Place the model in the water to accurately dim out the RC components (see page 6).
5. Mark the position of the battery and controller in the fuselage so that they can be installed again
in the same position when changing.
Now connect the speed controller and the rudder servo to the corresponding outputs
of the receiver.
Assembly instructions harbour tug
FAIRPLAY No. 1199
1199_Fairplay.indd 11
08.07.16 22:39
