During startup, press and hold the
a
switch to enter
debug mode. In this mode you can check the indivi-
dual buttons and lights. The current firmware version
is also displayed at device startup.
Each button lights up when pressed. Buttons 1-8
also send out a trigger via the respective jacks.
Press buttons
h
and
o
simultaneously to switch to
normal sequencer mode.
You can also use this mode to turn the
sequencer into a 8-trigger pad.
If you prefer to use the module upside down, you
can press the
s
key when starting the module. This
will rotate all keys of the control panel by 180°. This
option is mainly intended for experienced users, as
the function of the buttons no longer matches the
labeling. You can turn the knobs back to their initial
position when you press the
s
button during startup.
Debug Mode
Flip Mode
