Page: 3
INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic.
Place the bun warmer on a firm, level surface in the required position. Before
connecting the unit to the power supply ensure that all the controls are in the “OFF”
position.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained. If
the machine is near particularly heat-sensitive materials common sense should be
employed in determining sufficient distancing.
Plug the unit into a standard, single phase, 10Amp power point.
OPERATION
M6T
The left hand energy regulator (marked "B") controls the back three spikes while
the right hand regulator (marked "F") controls the front three spikes. Turn one or
both energy regulator knobs to "HI", as required. This will heat the spikes. Push a
bun over each spike and leave until warm. Slide buns off and insert hot dogs.
Lower settings can be selected on the energy regulators to cycle the elements, as
desired.
M3TS1
This unit operates the same as the M6T, except that there is only one energy
regulator in the hot dog warmer. This regulator operates all the spikes on the
machine.
PLEASE NOTE:
This ROBAND
®
machine is supplied with Teflon
®
coating to the spikes. The coating
utilised is the best quality currently available from Dupont Ltd and is applied by a
specialist in such coatings. However, neither Roband Australia Pty Ltd nor Dupont
Ltd are able to guarantee the performance or longevity of these coatings other than
for faulty workmanship. This is due to the protective coating nature of the product
and its use in unknown commercial environments.
It is important that Teflon coated spikes do not overheat or else discolouration or
degradation of the Teflon coating can occur. Do not leave Teflon coated spikes on
High power settings for periods longer than 5 minutes unless constantly in use. Teflon
coating is not covered under warranty.
