Page: 3
INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic using
methylated spirit.
Place the Toaster on a firm, level surface in the required position. Adjust the feet if
necessary to level the unit if the surface is slightly uneven. Before connecting the
toaster
to the power supply ensure that all the controls are in the “OFF” position.
Plug the machine into a power outlet matching the plug type supplied.
Always ensure the power cable is not in contact with hot parts of the toaster when in
use, and have any damaged power cord replaced immediately.
We recommend the use of an RCD (Residual Current Device) rated at not less than
30mA for circuit protection when using these units. Note that if one RCD is used to
protect multiple socket outlets, the RCD shall be appropriately rated so as to allow up
to 30mA from these machines alone.
Any damage caused to adjacent surfaces or equipment as a result of the unit being
too close will not be covered by warranty. Roband recommends a minimum gap of
100mm be maintained all around the unit to allow adequate ventilation and to prevent
any damage to heat sensitive materials.
We recommend the use of an RCD (Residual Current Device) rated at not less than
30mA for circuit protection when using these units. Note that if one RCD is used to
protect multiple socket outlets, the RCD shall be appropriately rated so as to allow up
to 30mA from these machines alone.
