Page
9
ETP Series optional panels.
Note: All ETP panels are supplied with double sided tape to fix them in position. This
tape should be stuck to the trolley frame rail at the top of the frame not to the rail closest
to the castors.
1. Wipe down the trolley frame removing any excess machine oil.
2. The end panels are inserted into the trolley frame first. Below is a picture of the
end panel inserted in position. The panels should slot into the frame neatly with
the flanges of the panel sitting square with the trolley frame.
3. Insert the front panels in the same manner but
do not stick them down yet
.
Install the smaller outer panels (300mm wide) first. If your ETP set has been
supplied with additional larger panels (325mm wide) then place them in between
the outer panels. These panels have been designed to have a 1mm gap on either
side of each panel once installed. Before you stick them in position, arrange them
so that this clearance is achieved and hold them temporarily in place with some
sticky tape. Once you are happy with their positions, use the supplied double sided
tape to stick them permanently one at a time.
ET Series panels
ETP Series panels (charges additional)
Size
Shelf
Outer
Panels
Shelf
Centre
Panels
End Panels
Front Outer
Panels
Front Centre
Panels
22
2
-
2
2
-
23
2
1
2
2
1
24
2
2
2
2
2
25
2
3
2
2
3
26
2
4
2
2
4
