ROBAND DCP23, Руководство по эксплуатации

Страница: 13 / 21

Page: 10
TROUBLESHOOTING
Symptoms Action
Display is Blank
Check that the unit is plugged in
Check voltage at the power outlet
Power on, but Pan not heating
Check that the pan is suitable for induction
cooking
Check pan is positioned in the center of the top
plate
Unit stops heating or output is
lower than usual
Check products ventilation
Check that the unit has not overheated and
entered “Overtemp” mode. Check by measuring
the temperature of the ceramic surface to see if it
is abnormally hot. If so, switch off, check vents
and contents of pot, then allow to cool before
using again
Check the timer set value
Check if the 12 hour run time has been exceeded
and press start again
Error Display Codes
U, 00
Make sure the Pan is a valid for Induction cooking
Check that the pan has a flat bottom
E4, E6
Turn off and unplug the unit, allow to cool, then
plug back in and trying again
E5
Check that the temperature sensor is connected to
the product correctly
“E5” means that the sensor is not connected
E2, E3,
E7
Turn off and unplug the unit, wait 1 minute, then
plug back in and trying again
E1, E8,
E9
Contact service agent