ROBAND DCP23, Руководство по эксплуатации

Страница: 10 / 21

Page: 7
OPERATION
Timer Function only available on DCP23
5. Using Timer Function
– To activate Timer Function;

Press power button to turn machine on

Press Timer Button
. At first, “720” will be displayed

Press the “Min/Sec” button. “720” will blink. By turning the “Control Knob”
the desired cooking time can be selected. (From 1sec, to 720min).

To adjust in 1 second increments, press the Min/sec button once more and
Seconds will blink. Use the knob to select the desired time.

To begin timer cycle press Start Button.

To control heat levels during timer cycle, press the timer button again then
use the control knob to select the desired heat setting.

At the end of the timer cycle the operation will stop. To restart timer
sequence, press “Start” button again. The same power setting will be used
as previous cycle.

To change
power levels, press the “Power Button”
Temperature Mode only available on DCP23
6. Temperature Mode

Press power button to turn machine on

Next press the “Mode” button. “000C” is displayed

Press the “Start” button. The display will show 50°C.

Set the desired
cooking temperature by turning the “Control Knob”

The display will alternate between showing “Actual Temperature” and “Set
Point Temperature”

When the “Set Point Temperature” has been reached, the display will stop
alternating.
If the Temperature sensor
is not connected and the “Mode” button is pressed,
the display will show error “E5”
Warning: Roband is not responsible for any damage to the equipment or injuries
caused by misuse or negligence.