Robalo 2012 220, Руководство владельца/оператора, Страница: 82 / 143

Fueling Procedures
1. Always fuel in an area which has sufficient lighting. Gasoline
spills are hard to see when lighting is poor or it is dark.
Important: When fueling or having someone else fuel your
boat, be sure the waste or water fill caps are not mistaken for
the fuel fill cap. Also, make sure a fishing rod holder is not mis-
taken for a fuel fill plate.
2. Your Robalo boat has fittings for filling the fuel tank. Remove
fuel fill plate. Insert the fuel supply nozzle. Allow nozzle to stay
in contact with fitting to prevent possible static-produced sparks.
Note: The fuel fill cap may have a built in tank ventilation fea-
ture. If you should need to replace the cap, see your dealer for
the exact same cap to ensure proper fuel system operation.
3. After pumping approximately 5 gallons of fuel into tank, inspect
bilge and fuel tank area for any signs of fuel leakage. Continue
fueling if you do not detect any leaks or other problems.
4. Allow space at the top of the tank for thermal expansion. Do not
overfill tank so that fuel comes out fuel tank vent.
Note: Do not over fill tank, causing fuel to spill onto water.
5. If fuel can not be pumped in at a reasonable rate, check for a
plugged fuel vent plug or kink in the line.
Post-Fueling Procedures
1. When you have finished fueling, replace fuel fill cap and wash
off any fuel spillage around fuel fill area. Discard, in a safe place,
any rags you may have used to wipe off fuel spills.
2. Open bilge compartment and all hatches, windows, doors and
compartments closed during fueling. Inspect these areas for fuel
fumes or fuel line leakage visually and by smelling. Check out
any sign of fuel leakage or any indication of fumes and correct
problem before starting the engine.
OPERATING YOUR BOAT
Starting the Engine
Important: Falls from moving boats are a major cause of fatal
recreational boating accidents. Do not allow passengers to ride
on the bow with feet hanging over the side or ride while sitting
on the stern, gunwales, or seat backs. The Coast Guard con-
siders these acts to be negligent or grossly negligent operation
and prohibits them by law.
The following information is only a general guide. Chapter 3 has
specific starting instructions for boats with battery selector switches.
Detailed instructions are also in the engine owner’s manual. Be sure
to read and follow all of those instructions.
1. Secure boat to the dock or mooring slip before attempting to
start engine. Keep boat secure until engine is running and
warmed up.
2. Check lubricating fluid levels. Check fuel supply and outboard oil
to make sure you have enough fuel for your planned excursion.
5-7
DANGER: Carbon Monoxide Hazard! A cold engine pro-
duces more carbon monoxide than a warm engine. Provide
adequate ventilation in the cabin and cockpit to prevent expo-
sure and reduce the possibility of carbon monoxide
accumulation. Open all hatches, doors, windows, and side
vents to increase air movement.