English
English
5
6
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connecton and replace the fuse. If the fuse blows again
after the replacement, there may be an internal malfunction. In this case, consult your
nearest repairing centre.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause
serious damage.
OPERATING INSTRUCTIONS
1. POWER ON/OFF
Insert the front panel in the unit and push Power button in order to switch on the unit. Push
PWR button newly in order to switch off the unit and push REL button (14) to release the
front panel.
Note:
Never release the front panel when the unit is on. Power remains on even when car
radio is off.
2. SCAN
Press this button to scan the stored programs of the Radio.
3. VOLUME UP/DOWN / ENTER
Rotate the VOLUME Knob (3) to control the VOLUME. To select other functions, press the
VOLUME (3) button shortly until the desired functions is shown on the display. Figure 1
shows how control functions are selected by pressing VOLUME button.
Fig. 1 Selection of sound control functions
1. VOLUME (rotate knob)
Detaching and attaching the front panel
The front panel of this unit can be detached in order to prevent the unit from being stolen.
DETACHING THE FRONT PANEL
Before detaching the front panel (14), be sure to press the POWER button (1) To Off first.
Pull out the panel towards you in order to detach completely the panel from the main unit.
ATTACHING THE FRONT PANEL
Make sure the front panel is the right way up when attaching it to the unit as it cannot be
attached upside down. Bring side B of panel to side A of main unit.
Insert the panel in and push until it clicks.
Notes:
•
Do not press the front panel hard against the unit when attaching it. It can be easily
attached by pressing it lightly against the unit.
•
When you carry the front panel with you, put it in the supplied front panel case.
•
Do not press hard or give excessive pressure to the display window of the front panel
when attaching it to the unit.
BUILT- IN ISO CONNECTOR
CONNECTOR A
1.
2.
3.
4. 12V
5. AUTO ANTENNA OUTPUT
6.
7. +12V (TO IGNITION KEY)
8. GROUND
Note:
12 V wire (connector A no. 7) must be connected by car ignition key in order to avoid
that car battery becomes weak when the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
