Page 5
For technical questions, please call 1-888-866-5797.
Item 62684
Operating Instructions
NOTICE: To prevent blowing a fusible
link on the receptacle, only use with
15 amp rated 12
V auxiliary power outlet.
1. Place the Power Switch (11) and
the LED Switch (16) in their O (off)
positions. Plug into a 15
A rated
12
V auxiliary power outlet ONLY.
Note:
This Defroster can burn
out lighter sockets.
2. Mount on dashboard, or hold over
windshield for spot defrosting. Use
for up to 20 minutes, and then
shut off for at least 5 minutes.
3. The Defroster can be removed from
the Mounting Base (6). By holding
the Handle (4/5) the Defroster can
be moved around as needed.
4. The LED Switch turns the lights on/off.
5. To select either the fan only or the
Defroster and fan, press the Power
Switch to the setting as marked.
Toggle the Power Switch to the center
position to turn off these functions.
WARNING! Do not operate longer
than 20 minutes at one time, allow
Defroster to cool completely after use.
6. Unplug the Defroster before
leaving the vehicle.
If Defroster suddenly stops operating:
WARNING! TO PREVENT FIRE:
Replace fuse only with fuse
of same type and rating.
1. Pull the Fuse (15) out of the
Fuse Holder.
If the wire inside the Fuse is broken
the Fuse needs to be replaced,
otherwise insert the Fuse back into the
Holder and proceed to the next step.
2. If the Defroster’s Fuse was not blown,
connect another 12
VDC device to the
12
V auxiliary power outlet to check it.
a. If the receptacle works, have
the Defroster serviced by
a qualified technician.
b.
If the receptacle does not work,
DO NOT USE THIS DEFROSTER
WITH THAT RECEPTACLE.
That receptacle is evidently not
rated to 15
A, as this Defroster requires.
Receptacles with a lower rating
will be permanently disabled
by this Defroster’s amp draw.
Note:
Check vehicle’s service manual for
instructions on repairing the receptacle.
Likely failure points are the fusible link on
the receptacle itself or the vehicle’s fuse.
