RoadScan Canada DH22, Руководство пользователя

Страница: 10 / 20

●
27/33 -
​
Coding format
​
: H.264/H.265 - compression factor of files allows for twice the files in less room - essentially doubling the gb’s on the
camera
●
28/33 –
​
Date-time stamp
​
: Change the date and time of the device.
●
29/33 –
​
ID Setting
​
: Allows to designate the camera to a specific person by entering a unique user ID.
●
30/33 –
​
Password:
​
Having this setting on will cause the password requirement before entering the menu and playback screens. Options are
on and off
●
31/33 –
​
Change Password
​
: Allows the user to change password. User must enter the old password and then the new password followed by
confirmation of the new password using the Scroll and OK buttons. *Note: remember your new password as it is non-recoverable and will be
required to be sent back to the manufacturer for resetting. This is a protection measure against unauthorized viewing of your data should the
camera be lost.
●
32/33 –
​
Default Setting
​
: Allows the user to reset the device to the default settings.
●
33/33 –
​
Version
​
: shows the version of the device.
Page 7
Special Features
Infrared:
​
Press the
​
infrared button
​
to manually turn the IR on, if the camera is set to
‘automatic IR’ then there is no need to turn the IR on manually (when IR is on, two red lights
will appear on the front of the camera)
Flashlight (White LED):
​
Hold the
​
infrared button
​
for 2 seconds for the flashlight to turn on /
hold again for 2 seconds to turn off the flashlight.
White Beacon:
​
Hold the
​
photo button
​
for 2 seconds to turn on flashing white beacon. Hold
again for 2 seconds to turn it off.
Charging
There are several ways to charge the camera which results in the blue light being illuminated.
If the blue light does not illuminate then the USB may not be seated properly.
​
DO NOT FORCE
INTO THE BASE
​
. The camera may be on and in use or the camera may not be seated properly
in the charging base. Make sure to correctly place the camera into the charging base - the
front of the camera should be facing away from the USB port on the charging base. If the
blue light is not on, the camera is not charging. It takes approximately 4-6 hours for the
camera to fully charge.
NOTE: If the camera is on while charging and becomes unplugged from the power source (via
the docking station or USB port) the camera will power off.
Ways to charge
1. Use the outlet adaptor, USB cable and charging base to plug into an outlet
2. Use the outlet adaptor and USB cable only to plug into an outlet
3. Plug the USB cable directly into the computer
4. Use the charging base with the 12 volt adaptor while in the vehicle