roadpixel Protector P101, Быстрый старт

Страница: 3 / 4

Recommended Installation
1.
Clean the windscreen inside and out to
ensure clearer images and easy adhesion.
2.
Attach the camera to the windscreen
bracket and affix the 3M sticker.
3.
Plug the 5V power adaptor into the
cigarette lighter or 12V socket and the other
end into the Drive Recorder’s DC5V power
input. The Drive Recorder will start up and
then begin recording automatically.
4.
The camera should be positioned near the
top of the windscreen close to the rear-view
mirror. Tilt the camera so that the screen
shows only 20% of sky at the top and a
small amount of bonnet at the bottom.
5.
Work out your best cable run to the 12V
power supply (see diagram).
6.
Starting from the camera using a small
object e.g. a credit card, carefully tuck the
cable between the windscreen and rubber
seal. Once at the corner tuck the cable
down the appropriate pillar between the
door and the dashboard (see diagram) and
run under dashboard to 12V power supply
using the self-adhesive cable clips supplied.
7.
If you have any problems installing the Drive
Recorder then please contact our Technical
Support Team:
Tel: 01763 878412
Email: support@roadpixel.com
Camera Setup
Insert the Micro SD Card (also known as a TF
card) into the slot at the top of the unit with the
gold fingers facing the BACK of the camera.
Push home to secure.
Notes:
Inserting the Micro SD Card incorrectly may
damage it.
To remove the Micro SD Card, use a finger nail to
press and release.
Only high speed (Class 10) cards are
recommended.
Switch on or off by holding the On / Off Button
for 3 seconds.
The display can be switched off and on by
pressing the Menu button for 3 seconds.
Make sure you are in Video mode – a film strip
icon will be on the top left of the screen. If you
press the Camera button – this will change to
a camera icon and the unit is ready to be used
as a still camera. To change back press the Up
Button.
Press Menu to enter the Setup options and
Menu again for further settings.
Navigate through the menus using the Up and
Down buttons on the back of the camera on the
right hand side and select each item using the
OK Button and change values by again using the
Up / Down Buttons.
Recommended Installation Position
Basic Recommended Settings
Set Time Stamp On
Set Motion Detection to Off
Set Loop Recording to 5 minutes – this creates a
new file every 5 minutes
Set the Time and Date using the Date Menu
The Drive Recorder is now ready to use, the
other factory settings should not need to be
adjusted unless you want to turn audio recording
off etc. More details are given in the full User
Manual which is available for download from the
RoadPixel website.
3