The following instructions must be followed in the order listed to ensure a proper installation
and to preserve the ROADMASTER warranty.
INSTALLATION
800-669-9690
Sprinter Van 3500 Rear Anti-Sway Bar Kit • 3
1. Remove the factory anti-sway bar from the axle.
Do not disconnect the endlinks from the frame (Figure 1). Retain all
hardware, you will be using it later.
2. Install the new anti-sway bar.
Install the endlinks to the anti-sway bar. With the ends of the bar fac-
ing straight up, insert the bolts and hand tighten (Figure 2).
3. Install the poly bushings with grease on the bar.
Rotate the bar into position and with the bushing clamp (B140) posi-
tioned off the bushing, start the bolts (Figure 3).
Note:
use Loc tite on
the bolts.
Note:
when reinstalling the brake line locators, they may need to be
trimmed (Figure 4).
Figure 1
Figure 2
WARNING
The anti-sway bar is heavy, and may cause property damage or per-
sonal injury if it falls on equipment, engine components or any part of
your body. Ensure that the anti-sway bar is supported and that you are
out of the way when removing the brackets.
Failure to follow these instructions may cause property damage,
personal injury or even death.
Figure 3
