4
7.
Connect the new battery to the light. The red lead should be connected to the red
positive battery terminal and the black lead to the black negative terminal. Hold
the insulated lead connector, align with the battery terminal and push fully into
place. Ensure insulators are in place over the connectors. It is recommended that
a sighted person assists with this operation.
8.
Insert the battery into the light taking care that the leads don’t get trapped
between the battery and the housing. Push the battery fully into place.
9.
Replace the light base ensuring that the screws are put back into the correct holes
and tightened.
Caution:
Do not over tighten the screws.
Caution:
Do not operate the light without the battery.
Technical specification
Battery or mains operated
Charge status indicator
Average lumens 520
Up to six hours of portable light when fully charged
Height 300mm (11.8 inches)
Weight 1500g without packaging
Hints and Tips
If the light does not work please check the following:
Is the battery charged? Plug in the power unit and check the colour of the charge
indicator – see
The
c
harge indicator explained
section.
Is the battery is properly connected? – see
Replacing the battery
section.
Is the power unit jack fully inserted into the light?
In the unlikely event of the shade becoming loose, remove the pivot end cap using the
end of a straight paper clip. (The pivot end cap, also referred to as the round hinge in
the
Orientation section
is the round pivot that is connected to the carry handle).
There is a small access hole in the middle of the edge cap to enable removal (this is
the right pivot with the back of the light facing towards you). Tighten the screw
sufficiently until the shade holds in position. Do not over tighten. Replace the end cap.
Safety and cleaning
Caution - if the cable becomes damaged, the light should not be used and the cable
should be replaced by a suitably qualified person (qualified electrician).
After removing from mains power supply, the light can be cleaned with a duster or
damp (not wet) cloth containing a mild soap solution and then dry with a soft cloth. Do
not use spray cleaners or large amounts of liquid.
