Rhein - Nadel Automation GmbH
3
14.04.2014
Bowl feeder VT-BA-SRC63-100-GB
Notice
All vibratory bowl feeders listed in the table may only be operated in connection with a RNA control unit
at a mains voltage of 230V/50Hz. Special voltages and frequencies see separate data sheet.
1 Technical data
Vibratory bowl feeder type
1)
SRC-N 63-2
SRC-N 100-2
Dimensions ø x height
in mm
60 x 65
90 x 82
Weight
in kg
0,8
1,8
Insulation type
IP 54
IP 54
Connecting cable length
in m
1,4
1,4
Power consumption
2)
in VA
8
11
Current consumption
2)
in A
0,04
0,055
Magnet nominal voltage
2)
/frequency
in V / Hz
230 / 50
230 / 50
Air gap [mm]
in mm
0,3 - 0,4
0,3 - 0,4
Number of magnets
1
1
Vibration frequency
in Hz/min
-1
100 / 6000
100 / 6000
1)
The last figure of the type identification shows the Vibration frequency: 1=50Hz (black mains cable),
2=100 Hz (grey mains cable)
2)
For special voltages (voltage, frequency) see type plate at the magnet
Pin assignment
2 Safety instructions
The conception and production of our vibratory bowl feeders has been carried out very careful, in order to
guarantee a trouble-free and save operation. You too can make an important contribution to job safety.
Therefore, please read this short operating instruction completely, before starting the machine. Always ob-
serve the safety instructions!
Make sure that all persons working with or at this machine carefully read and observe the following safety
instructions!
This operating instruction is only valid for the types indicated on the front page.
Notice
This hand points to information that gives you useful tips for the operation of the vibratory bowl feeder.
The bridge has to be installed in connection 3+4
