9
Unpacking Procedure for the PAL
1. Cut open the enclosure bag at the base of the unit and gently remove plastic
from unit.
2. Cut internal bands and remove chair assembly and housing.
3. Remove the accessory box and counterweight plate from the plate enclosure.
4. Remove the handle from the frame.
5. Remove the main frame from the pallet. Position the main frame close to the
pallet and lock the wheels.
6. Carefully transfer the 24 counterweights from the pallet following the
instructions on page 6.
7. Place housing on frame.
8. Remove 2 lock nuts and washers from mast mounting hub on base assembly.
9. Position mast assembly thru housing and attach to studs located on base
assembly with lock nuts and washers. Fully tighten with 3/4” socket wrench.
10. Remove twist-tie and uncoil actuator cable at bottom of mast.
11. Lift and slide the housing part way up the mast to gain access to frame area
under housing.
12. Run actuator cable along with the 24v motor cable across the top of the
weights and insert through the hole in the rear of the housing near the control
box.
13. Insert actuator cable (with the “o” ring) into receptacle #1 on the control box.
14. Insert 24v motor cable into receptacle #2 on control box. Make sure both
plugs are pushed in all the way.
15. Return housing to normal position and insert handle over attachments.
16. Remove and unwrap hand control from accessory carton. Insert connector
into large receptacle on control unit and hang hand control on handle.
17. Attach battery to control unit mounted on housing.
