4. OPERATING PROCEDURE
Ÿ
Switch ON POWER button of the indicator unit.
Ÿ
In indicator unit depending upon the water levels in each tank, the level
indication LEDs are ON. Furthermore, the levels of the each tank will be
monitored every 16 seconds and updates the indicator whenever there is
change in the water level . If the water level goes low, all LEDs will be OFF and
you will hear a low beep alarm for 60 seconds. If water goes to high level all LEDs
will be ON and you can hear a fast beep alarm for 60 seconds.
3
5. OPERATING PROCEDURE
6. TROUBLE SHOOTING METHODS
S. No. Error
Solutions
1
No
communication
between the
indicator and
transmitter
a.
Check whether any obstrucles are there in
between transmitter and receiver units like large
trees, buildings etc.
b.
Check the battery in transmitter is connected
correctly without any loose act.
c.
Check whether the battery is completely drained
out, If so charge the battery using the USB port in
it.
2
Tank level
indicator LEDs
are off
If one or all the level indicator LEDs are not glowing,
a.
Check common sensor connection is correctly
made. If any loose contact correct it.
b.
Check all the sensor connections are having any
loose contact. Also check if the cable lines are
intact.
Pairing Procedure:
The units are generally paired and dispatched. In case of any trouble at the
time of installation, users can pair the units once again.
Ÿ
·In Indicator Unit, Press the GREEN SET button and do not take the nger
out. While doing this, switch ON the power ON/OFF switch. All the tank level
LEDs will blink. It means the device is ready for pairing.
Ÿ
·In Transmitter Unit, there is a Push button inside it. By pressing the push
button without taking out the nger, insert the battery into the battery
case. Now the RF Signal LED inside transmitter blinks one time and all the
tank level LEDs goes off in the controller unit. Thus pairing is completed.
