3. Press the
Load
Button
.
8.2.3. Loading Factory Default Settings
The factory default settings are saved internally as
Preset 16
and cannot be overwritten.
To load the factory defaults, load
Preset 16
.
Loading the factory defaults does not delete any saved presets. It also does not affect
the
lock
settings in the
STATE
section.
8.3. Device Lock
The M-32 AD Pro can be secured against both accidental and intentional changes to its configuration.
Locking
the device, with or without code, protects against changes on the device itself. When locked,
the display shows a lock symbol.
The device lock does not protect against changes over network or MIDI remote control protocols. The
lock configuration is not stored within a
preset
.
A four to six digit code can be configured on the device. If this code is lost or forgotten,
it is not possible for the user to unlock the device. Contact your support for assistance.
8.3.1. Locking the Device
In order to lock the device, proceed with the following steps:
1. Open the
lock
tab in the
STATE
section
2.
(optional)
Set Code:
enter a four to six digit code with the encoder.
3.
(optional)
Activate the
Auto Lock
toggle to lock after one minute.
4.
(optional)
Select
Lock Device Now
to lock immediately.
Remember or write down the code shown in
SET CODE
. It is not possible to unlock the
device without this code. A unique secondary code (PUK) can be obtained from RME
Support upon request with a proof of purchase and device serial number.
To delete the code,
move the cursor on the code and push the encoder. "No code" will be displayed.
The device can only be locked and unlocked at the front panel. These controls are not accessible
remotely.
8.3.2. Unlocking the Device
To unlock the device
temporarily
:
1. Push and hold the encoder button for four seconds.
RME M-32 AD Pro User’s Guide
8.3. Device Lock |
26
Содержание M-32 AD Pro
Страница 2: ...RME M 32 AD Pro User s Guide ...
