RME Audio ADI-2 DAC, Руководство пользователя

Страница: 24 / 68

24 User’s Guide ADI-2 DAC © RME
Notes
The frequency graphics give a precise overview of the filter results. Overlapping filters influence
each other. This can be used to achieve more than 12 dB gain, or to generate difficult frequency
response optimizations.
The ADI-2 DAC has an internal headroom of 24 dB. Extreme boosts with overlapping filters
could cause an internal overload. Such an overload will be visible as it is displayed by the level
meter below the EQ, as well as the channel’s level meter. Reducing the output volume will pre-
vent any clipping as long as the headroom of 24 dB is not exceeded. In real-world operation
that is always the case, the ADI-2 DAC will not distort internally.
Pushing the EQ key a second time brings up the
EQ Enable / Presets screen. In this screen
the EQ can be switched on and off, and EQ presets can be stored and loaded comfortably.
EQ Enable
Default: OFF. Options are ON, OFF, L, R (L and R are only available with Dual EQ activated).
Preset Select
Load or store up to 20 different EQ settings. The first choice,
Manual, holds the current, unsaved EQ settings. The
second choice, Temp, holds the settings of a loaded and
then modified Preset. This scheme lets the user easily
change and compare three different EQ settings: the manual
one, the 20 stored presets and the modified preset, without
loosing changes while listening to a different set of EQ set-
tings.
The presets are independent from and not stored with Setups (see chapter 14.2). EQ Presets
are therefore always available, no matter which Setup has been loaded. The Setup does in-
clude the current EQ setting, which on load is written into the memory slot Manual.
Name
Allows to edit the name of the current preset and to edit the
name during the store process. Turn encoder 2 to select a
letter, number or symbol, then press encoder 2 briefly to
enter the next sign. After the last sign the cursor jumps to
the field
Store to
. The name can consist of up to 14 signs.
Turning encoder 1 gives access to all existing preset
names, so copying and modifying a preset can be done
more quickly.
Changing the name is always stored immediately during
editing, without further confirmation.
Leaving this field the name is automatically adjusted to the right. Adding signs to the front and
rear is possible afterwards. A quick turn to the left brings up space, which is also used to quickly
delete letters. Available signs are:
Space, Aa to Zz, + - / ( ) * ; : . , ! # $ & < > = ' I @, 0 - 9
Save to
Use encoder 2 to select the slot where the current preset should be stored to. To store press
and hold encoder 2 for one second.