RM Gastro S-200 ABT, Инструкция по эксплуатации, Страница: 18 / 55

Pag. 13
UK
•
Once drain is over, the machine will carry out two rinse cycles,
and will then be automatically switched off
•
Remove tension from the machine.
•
Open the door and remove the rack with clean dishes.
•
Drain the water from the tank by lifting the overflow-pipe. For the
model with drain pump please follow the operations described in
the «Use instructions» paragraph.
• Disconnect the main switch of the equipment.
• Close the «rolling shutter valve» for the hydraulic connection.
•
Remove the filters clean them under a water jet with a nylon brush.
•
Pay attention not to let any dirtiness rests on the bottom of the
drain pump filter inside the tank. Clean the tank with a moderate
water jet. Wash outside surfaces when are cold with non-abrasive
products which are especially studied for steel maintenance.
REMARK
: Do not wash the equipment with direct jet or at
another pressure because eventual infiltrations to the electric
components may harm the regular working of the equipment or
of the single safety systems, and penalty for this would be the
loss of guarantee.
4.5 HALF-LOAD ENABLE, FOR TT924 ONLY
The "half-load" function can be enabled when just a few objects have
to be washed. This allows saving power as well as water and
detergents.
1) Load the machine with the kitchenware to be washed well arranged
on the right side, as shown in
( Fig. 7 ) .
2) Open the door, and keep start push-button
3 pressed until warning
light M (Fig 8) comes on.
3) Close door, and enable the washing cycle as described in the
previous paragraph.
Pag. 13
GB
•
Once drain is over, the machine will carry out two rinse cycles,
and will then be automatically switched off
•
Remove tension from the machine.
•
Open the door and remove the rack with clean dishes.
•
Drain the water from the tank by lifting the overflow-pipe. For the
model with drain pump please follow the operations described in
the «Use instructions» paragraph.
• Disconnect the main switch of the equipment.
• Close the «rolling shutter valve» for the hydraulic connection.
•
Remove the filters clean them under a water jet with a nylon brush.
•
Pay attention not to let any dirtiness rests on the bottom of the
drain pump filter inside the tank. Clean the tank with a moderate
water jet. Wash outside surfaces when are cold with non-abrasive
products which are especially studied for steel maintenance.
REMARK
: Do not wash the equipment with direct jet or at
another pressure because eventual infiltrations to the electric
components may harm the regular working of the equipment or
of the single safety systems, and penalty for this would be the
loss of guarantee.
4.5 HALF-LOAD ENABLE, FOR TT924 ONLY
The "half-load" function can be enabled when just a few objects have
to be washed. This allows saving power as well as water and
detergents.
1) Load the machine with the kitchenware to be washed well arranged
on the right side, as shown in
( Fig. 7 ) .
2) Open the door, and keep start push-button
3 pressed until warning
light M (Fig 8) comes on.
3) Close door, and enable the washing cycle as described in the
previous paragraph.