65-2482RK Multi Point Detector • 7
Installation
This section describes procedures to mount the multi-point detector in the monitoring
environment and wire the detector to a controller.
Mounting the Multi-Point Detector
1.
Select a mounting site that is representative of the monitoring environment. Consider
the following when you select the mounting site.
•
Select a site where the detector is not likely to be bumped or disturbed. Make sure
there is sufficient room to perform start-up, maintenance, and calibration
procedures.
•
Select a site where the target gases are likely to be found first.
NOTE:
If your application does not require a specific mounting site, mount the detector
at approximately breathing level.
Figure 5: Outline & Mounting Dimensions 65-2482RK-01
3/4 NPT HUBS (4X)
.25
3.11
Oxygen
Detector
1.10
2.40
LEL(CH4 IR)
Detector
H2S
Detector
3.00
3.15
.20 DIA X .45 Slot,(2X) ,mounting
1.25
3.00
7.75
8.24 max.
