28 • Chapter 5: Setup Mode
AirLink 9850 Gas Monitor Operator’s Manual
3. Port Selection: Press
ADD
or
SUB
to select the 4-20 mA port that you want to manipulate. There
are 8 ports on each 4-20 mA Output Terminal Board and they are each labeled 1-8. If you want to
manipulate the settings for the 8th port on the 4th card, you need to select Port 32 in this sceen.
4. Press
MENU
.
5. On/Off: Press
ADD
or
SUB
to turn the port on or off.
6. Press
MENU
.
NOTE:
The following screens only appear if the port was set to On.
7. Setup Address: The Setup Address assigns which AirLink sensor assembly’s radio address is
assigned to the selected 4-20 mA port. Press
ADD
(increase) or
SUB
(decrease) to manipulate the
setup address (1-255).
8. Press
MENU
.
