16 • 35-3001A-01-XX1 Sample-Draw Detector Operator’s Manual
CAUTION:
If using shielded cable, leave the cable shield’s drain wire insulated and
disconnected at the sample-draw detector. You will connect the opposite end of
the drain wire at the controller.
7. Route the cable or wires in conduit leading from the sample-draw detector through one of
the conduit hubs at the controller.
8. Connect the wires to the applicable detector/transmitter terminal strip at the controller as
shown in Figure 5. Refer to the controller operator’s manual and the controller detector
head specification sheet for the 35-3001A-01-XX1 for detector/terminal strip connections
specific to the controller.
