WAC8112INS V1 05/08/16 JE LH
E&OE Copyright © 2016 RKC Holdings Pty Ltd
Air filter condition is directly related to compressor
location, driving environment and compressor usage.
For high debris applications inspect the air filter every
month.
STEP 5
– COMPRESSORS WIRING AND AIRLINE CONNECTION
Use the supplied Air and Electrical Connections diagrams as a guide for your dual compressor air line and wiring connections. Use
the instructions supplied with your Airbag Man Air Control system kit for specific air line and wiring connections.
NOTE:
Only one Pressure Switch is to be installed and this is wired to activate both of the supplied relays as shown. Where
possible, we recommend for each compressor outlet to be connected at opposite ends of a common air tank for best output
performance.
STEP 6
– USE & MAINTENANCE
Periodically check that the air filter for the air compressors is clean. Spare filters are provided for replacements and they may be needed
often if the compressor is operating in a dusty environment.
Regularly clean dust and debris from the compressor fins and motor housing.
Periodically check the electrical and pneumatic connections are tight and not damaged.
Periodically check the fasteners for the compressor, tank and control panel are tight.
The air compressor is equipped with a permanently lubricated, maintenance-free motor. Never try to lubricate the air compressor.
If the air compressor runs for a long period of time it may turn off due to its internal Thermal Overload Protector. If this happens turn
the power off and allow the unit to cool for about 30 minutes. This will allow the protector to reset so you can safely resume use of the
compressor. In the event of the compressor repeatedly turning off early or blowing fuses check that the battery voltage is sufficient, the
wiring is suitable and in good condition, the pressure switch is not faulty and that the relay is working correctly.
If all the electrical components appear correct then check that the compressor had adequate ventilation and is clean. If problems still
occur the compressor may be worn out and in need of replacement.
CAUTION: Never touch the air compressor or fittings connected to the air compressor with bare hands during or
immediately after use. The leader hose (where fitted) and fittings connected to the leader hose or pump head will
become very HOT during and after use. If necessary wear heat resistant gloves to handle fittings, airline and leader hose.
Incorrect use of this product can result in damage to the components associated part and/or the vehicle, which is not
covered under warranty.
Ensure suspension airbags are maintained at the stated ride height at all times and maintain the minimum pressure
required and never exceed the maximum, as required by the particular airbag product.