RK Rose+Krieger RK MonoLine R, Руководство по сборке

Страница: 102 / 132

5.4.2 Assembling the synchronisation shaft
5.4.2.1 Assembling the synchronisation shaft (without protective tube)
Version RK MonoLine Z
Size 40/60/80/120
Personnel: n Assembly staff
Protective equipment: n Protective clothing
n Protective gloves
n Safety shoes
Prerequisites:
n The electric gear unit and/or motor (if available) are secured
against restarting.
n Linear units to be connected must be fixed in the substrate.
1. Place the screw-in hubs (Fig. 23/2) on the timing belt shafts
(Fig. 23/1) of both linear units.
2. Tighten 4 screws each (Fig. 23/3), alternating diagonally:
Size Screw size Tightening torque [Nm]
40 M4 4.2
60, 80, 120 M8 40
3. Insert gear rings (Fig. 23/4) into the screw-in hubs.
4. Place the clamping hubs (Fig. 24/2) on both sides of the steel
tube (Fig. 24/3).
Do not fix the clamping hubs to the steel tube
yet.
5. Place the steel tube (Fig. 24/3) with the loose clamping hubs
between the screw-in hubs of both linear units.
6. Slide clamping hubs (Fig. 24/2) into the screw-in hubs
(Fig. 24/1).
Ensure that the clamping hubs on the steel
tube engage correctly in the screw-in hubs
on the linear units.
7. Tighten the screw (Fig. 24/4) on each clamping hub.
Applicable to
Assembling screw-in hubs
Fig. 23: Assembling screw-in hubs
Assembling the synchronisation
shaft
Fig. 24: Assembling the synchronisa-
tion shaft
Assembly
Assembling optional modules > Assembling the synchronisation shaft
14.10.2021 Linear unit RK MonoLine R/RK MonoLine Z 102