18
OFF/ON state by closing its contacts for a short time and then re-opening them. In momentary mode, the Rack Gizmo
switches will close for 100 milliseconds before opening again.)
To enter momentary mode, hold down the Audio Loop 3 button while powering up the Rack Gizmo. Keep holding the
button until the LEDs flash. Use the front panel buttons to light the LED of any function that needs to be momentary.
Make certain that no other LED is lit.
Once you’ve selected the buttons for the momentary functions, press the Write button. The Rack Gizmo is now in
normal operational mode and the momentary functions should operate correctly.
Group Mode
The Group feature allows you define a group of buttons where pressing one button of the group turns that button on
and turns all other buttons in the group off. This is typically used for function switches that control which channel is
selected on an amplifier. This prevents the Rack Gizmo from trying to activate more than one amp channel at a time.
To enter group mode, hold down the Audio Loop 4 button while powering up the Rack Gizmo. Keep holding the
button until the LEDs flash.
Use the front panel buttons to light the LED of any function that should be in the group. Make sure that no other LEDs
are lit.
Note: The groups for Audio Loops and Function Switches are separate. If you set both Audio Loops and Function
Switches to be part of a group, pressing an Audio Loop button will only affect other Audio Loops, and pressing a
Function Switch button will only affect other Function Switches.
Once you’ve selected the loops that need to be grouped, press the Write button. The Rack Gizmo is now in normal
operational mode and the grouped buttons will now only allow one button to be selected at a time.
Quick Setup Buttons
Quick Setup buttons are provided to quickly set up the Function Switches for common configurations. Which
configuration you use depends on the number of channels your amplifier has, and whether the amplifier uses
momentary switching or not.
To use this feature, hold one of the following buttons while powering up the Rack Gizmo. Hold the button until the
LEDs flash. The Rack Gizmo will configure the Function Switch buttons as follows:
Hold Function Switch 1:
No switches momentary or grouped. (Default setting)
Hold Function Switch 2:
First two switches grouped, no switches momentary. (Most 2 channel amps)
Hold Function Switch 3:
First three switches grouped, no switches momentary. (Most 3 channel amps)
Hold Function Switch 4:
First four switches grouped, no switches momentary. (Most 4 channel amps)
Hold Function Switch 5:
All switches momentary, none grouped. (Rivera M and S amps)
Hold Function Switch 6:
First two switches grouped and momentary.
Hold Function Switch 7:
First three switches grouped and momentary. (Bogner Ecstasy, EVH 5150III)
Hold Function Switch 8:
First four switches grouped and momentary. (Marshall Mode 4)
Once the button has been held and the LEDs have flashed, release the button and the Rack Gizmo will go directly to
normal operating mode.
Содержание Rack Gizmo
Страница 1: ...Rack Gizmo User s Manual RJM Music Technology Inc TM...
Страница 2: ......
Страница 7: ...2 Front Panel 1 2 3 4 6 5...
