Rize Fixie, Руководство пользователя, Страница: 9 / 20

(F) Pedals
(required tools: 15mm wrench, recommended torque 35-40 N.m)
The right and left pedals are marked with an "R" or "L" on the end of the thread. The right pedal axle has a smooth surface
whereas the left pedal axle has grooves.
The pedal and crank threads are designed to line up easily. Be sure to tighten the pedals with your hand, first. It should be easy
for the first few turns. Do not force if tightening is difficult. If the tightening is difficult, stop immediately as the pedal thread is not
aligned and continuing to do so will damage the thread of the crank arm.
1. Apply a small amount of grease onto the pedal thread axle.
2. Insert the right pedal into the right crank arm. Carefully thread the pedal clockwise onto the crank, by-hand, slowly and then
fully tighten.
3. Insert the left pedal into the left crank arm. Carefully thread the pedal counter-clockwise onto the crank, by-hand, slowly
and then fully tighten.
Inserting the pedal into the wrong side, installing at the wrong angle, or failure to tighten firmly will and strip
the crank arm thread and will cause the pedal to detach.
(G) Seat
1. Open the seat tube lever, insert the seat post, and close the lever to lock.
2. Rotate the lever to adjust the lock tightness.
3. Adjust the seat angle by loosening the bolt underneath the seat. You can tilt the seat up or
down and move it forward or backward to fit your comfort
(r equired tools: 5mm hex key,
recommended torque 25 N.m )
.
Do not raise the seat post beyond the minimum insertion point line. Doing so
may cause the seat post or frame to break and can result in serious injury or death.
6
© 2021 Rize Bikes
WARNING
WARNING