RivieraPool Penta P, Инструкция по установке и эксплуатации

Страница: 13 / 16

13
Diagnosemeldungen
Reminder
messages
Frequency Action required
rPH Every 7 days Check and set chemical content according to the manufacturer's instructions.
rSH Every 7 days Check and set chemical content according to the manufacturer's instructions.
rLL Every 30 days Remove filter, clean it and re-install according to manufacturer's instructions.
rL9 Every 30 days Check and reset GFCI circuit breaker according to manufacturer's
instructions.
rdr Every 90 days Empty and refill whirlpool according to manufacturer's instructions.
rLL Every 180 days Clean and treat covering according to manufacturer's instructions.
rLr Every 180 days Clean and treat wood according to manufacturer's instructions.
rLH Every 365 days Install new filter.
F1 lit up Filter time 1 activated
F2 lit up Filter time 2 activated
PL lit up Button lock active
TL lit up Temperature lock active
Diagnostic
message
Meaning Action required
--F
--C
Temperature not recognised. After the pump has been switched on for 2 minutes, the temperature is
displayed.
---
Current temperature not in sleep or save mode. In sleep or save mode and outside a filter cycle, the pump stays switched off,
potentially for a number of hours. To display the current temperature either
switch to standard mode or turn on "Jet 1" for at least two minutes.
Sb4
Standby mode is switched on by pressing
multiple buttons on the operator console. By pressing any button the system leaves standby mode and switches back to
normal operation.