Rivet King RK-280-NP12, Инструкция по эксплуатации

Страница: 4 / 12

4
P
REPARING THE TOOL FOR SERVICE
1
1
1
.
..
Inspect for damage
2
2
2
.
..
Connect the tool to the air supply
3
3
3
.
..
Insure the Rivet Nut you wish to install is within the capacity of the rivet tool
4
4
4
.
..
Choose and securely install the applicable nose piece for the rivet nuts you wish to apply.
5
5
5
.
..
Bring the tool and the rivet into the application hole. Insure the rivet head flat onto surface
6
6
6
.
..
Fully actuate the rocker trigger. The top button will spin the rivetnut onto the mandrel and
install the rivetnut into the workpiece. The lower button will spin the rivetnut off the
mandrel.
JAMMED GUN REMEDY
1. Disconnect tool from air supply
2. Remove Nose Piece
3. Replace Mandrel if Necessary
4. Reapply the nose case securely to the tool
5. Reattach air supply. Actuate tool without rivet. Check Function.
6. Once comfortable, Apply Rivets nuts.
A
IR
S
UPPLY

The rivet tool is powered by compressed air at an optimum pressure of 5.5-6.0bar(80-90 psi)

The use of a pressure regulator filter/lubricator unit within 3 meters of the tool is highly
recommended to extend the life of the tool.
Dirt and/or water in the air supply can seriously impact the performance and durability of
the tool; damage to the tool caused by contaminated air supply is not covered under
warranty