Page 2 of 3
email: [email protected]
FURNITURE
Riverside
Precision Bed Room
Queen Bed
Assembly Instructions
21475 / 21875 5/0 STORAGE FOOTBOARD
21476 / 21876 5/0-6/6 BED RAILS
21470 / 21870
LOW HEADBOARD
21474 / 21874
TALL HEADBOARD
21472 / 21872
LOW UPH HEADBOARD
21478 / 21878
TALL UPH HEADBOARD
21475 / 21875 5/0 STORAGE FOOTBOARD
21476 / 21876 5/0-6/6 BED RAILS
Adj Glide
STEP 3
Detail E
Steps:
1. Lean the back of the Headboard against the wall where the Bed will be
assembled.
2. Install two All-Thread Bolts (R-B) into the metal threaded inserts installed in the
Headboard Legs and into the metal inserts on the Footboard. Insert the Wood
Dowel Pins (R-G) into the middle holes.
3. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on
the Headboard and connect using the Curved Washers (R-E), Spring Washers
(R-D), and Hex Nut (R-C). Only partially tighten the Nuts until the Footboard
has been connected. Repeat for other Bed Rail.
4. Position and connect the Footboard (F-A) to the other end of the Bed Rails,
attaching as in the previous Steps.
8. Carefully align the Footboard to be 'square' with the Headboard. Using the
Open Wrench (R-F) tighten all Hex Nuts attaching the Side Rails to the
Headboard and Footboard. (See Detail E).
F-C
F-C
F-C
F-D
F-D
6. Assemble Parts A & B of the Slat Support Rails (F-C) using the two 1-1/4"
long Bolts (F-F), Spring Washers (F-G) and Flat Washers (F-H). Assemble the
Slat Support Leg (F-D) to the Support Rails using the two 3" Long Bolts (F-E)
and the same Washers. Tighten all four Bolts with the Allen Wrench (F-J).
7. Position the Slat Support assembly into the pockets on the Headboard and
Footboard.
R-B
R-E
R-D
R-C
R-F
R-G
F-F
F-G
F-H
F-J
F-E
F-G
F-H
F-J
Note: Use these four holes
when assembling the Slat
Support Rails for a Queen or
Eastern King Bed.
Note: Use these four holes
when assembling the Slat
Support Rails for a California
King Bed.
68-3/8" For Queen / Eastern King
72-3/8" For California King
NOTE: The Slat Support Rails Parts A
& B, and Support Leg, can be
assembled to fit a Queen/King Bed or
to fit a California King Bed length,
depending on the sets of holes used.
Made in Viet Nam
