Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
8
Operator's Manual
CLASSIC XT 1-Man Ladder Stand
FIGURE
7A
FIGURE
7B
FIGURE 7
10. Attach the two provided 9 IN foam pads (9) to the armrests (8) by
wrapping around tubing and attaching hook and loop together.
11. Preassemble the 16' criss-cross straps (23) and 6' ratchet strap
(21) as follows:
a. Attach the two long ends of the 16’ criss-cross straps (23) to
each side of the rear frame tube on each side of the seat
platform tree blade (4). These long stabilizer straps should be
attached by pulling the free end of the strap through the loop
end of the strap to create a cinch knot around the frame tube.
SEE FIGURE 7A AND 7B.
b. To aid in the ease of installation, pre-attach each end of the 6'
ratchet strap (21) to each side of the rear frame tube, just inside
of the 16' criss-cross strap (23) on both sides of the seat platform
tree blade (4). Use the same method as listed in step a. This way
each end of the main ratchet strap is pre-attached before the
stand is lifted from teh ground. SEE FIGURE 7B showing all
four ends attached.
FIGURE
6
8. Attach the stabilizer bar extension tube (7) to the middle
ladder section (12) through the mounting bracket with one
lockpin (17). SEE FIGURE 6.
9. Slide the stabilizer bar (13) into the extension tube (7) and attach
the two pieces together using one lockpin (17). The lockpin must go
through both the extension tube (7) and stabilizer bar (13) at
appropriate hole to achieve desired distance from tree. Adjustment
in length may be needed when ladder is uprighted later in Setup
and Use Instructions. SEE FIGURE 6.
NOTE: Treestand should ALWAYS be fully assembled on
the ground prior to mounting it in the tree.
13
7
17
17
12
4
4
21
23
23
