1- Lay the step on the side and fix the support tubes on the step with the 3” bolt for the upper holes (4), the 3
1
/
2
” for the lower holes (4),
the nuts (8) and the washers (16). Slide the braces in the top of the shorter support tubes. (fig.1)
2- Fix the ramps on the support tubes with the
3
/
4
” screws (4). (fig.2)
3- Fill the ballast unit with sand and seal with the plastic cap.
4- Move the step into the water and allow the air to escape. Place the step by the pool wall leaving at least 1” between the step and the
wall. Put the ballast unit at the appropriate place on the step. (annexe a) Ensure that the step touches the ground solidly. Lower the
braces until its rests on the sidewalk. (annexe b)
5- Fix the braces on the sidewalk with concrete screws (not included). (annexe c)
1- Slide the braces in the top of the handrails. Lay the step on the side and fix both handrails on the step with the 3” bolt for the upper holes
(4), the 3
1
/
2
” for the lower holes (4), the nuts (8) and the washers (16). (fig.1)
2- Fill the ballast unit with sand and seal with the plastic cap.
3- Move the step into the water and allow the air to escape. Place the step by the pool wall leaving at least 1” between the step and the
wall. Put the ballast unit at the appropriate place on the step. (annexe a) Ensure that the step touches the ground solidly. Lower the
braces until its rests on the sidewalk. (annexe b)
4- Fix the braces on the sidewalk with concrete screws (not included). (annexe c)
