Riverlea Duratuf Guardian SHEDS GS63, Руководство по сборке

Страница: 11 / 16

ASSEMBLE FRONT PANEL
10
SELECT:
1 x 1.890 Wall Sheet
1 x 1.890 1Pan Wall Sheet
1 x 1.690 Top Plate (Red)
1 x 1.690 Bottom Plate (Green)
2 x 1.890 Door Jamb Flashings
20 x 30mm Galv Clouts
20 x Rivets
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface
as shown.
STEP 3:
•
Place 1 x 1.890 m Wall Sheet and 1 x 1.890 m 1Pan Wall
Sheet on timber, ensuring wall sheets fit underneath door
jamb flashings.
•
Ensure that the top of the sheet is flush with the top of the
Top Plate and that the sides of the wall sheets overhang the
Top Plate by
15mm as shown. Nail wall sheets to Top Plate
(two clouts per pan)
•
Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheet overhang the Bottom Plate by
15mm .
•
Drill & rivet Door Jamb Flashings to wall sheets using four
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
15mm 15mm
15mm
15mm
TOP
PLATE
DOOR
JAMB
NAIL
STEP 2:
•
Using 2 x 30mm clouts, nail the Door Jamb Flashing flush
with the top of the Top Plate at the correct measurement as
shown in plan view. Pre drill holes using a 3.5mm drill bit.
•
Check the distance between the top and bottom plates then
use a further 2 x 30mm clouts to nail the Door Jamb Flash-
ings to the bottom Plate. Pre drill holes.
198mm
960mm
TOP PLATE
DOOR OPENING
Plan View
BOTTOM PLATE
1859mm
TOP PLATE
1859mm
STEP 4:
•
Place the door on the panel (In open position, approx
25mm below top of top plate). Using two rivets, rivet the top
and bottom hinges to the Door Jamb Flashing, ensuring
door closes properly.
•
Fit remaining rivets.
x3
x3
x3
NOTE:
The Doorway is standard at 198mm from left - hand end.
To shift the doorway to the right - hand side of the front
wall, simply measure 198mm from the right - hand end.