24 | Replacing SteelConnect SDI-2030 and SDI-5030 Gateway Components
Field-replaceable units
Field-replaceable units
The SteelConnect SDI-2030 and SDI-5030 gateways contains field-replaceable units (FRUs) that you or
a certified service technician can troubleshoot, remove from the gateway, and replace without having
to send the gateway to a repair facility.
Figure 3-1. SDI-2030 and SDI-5030 gateway components
Caution:
Perform troubleshooting or repairs only as directed in the product documentation or by the online or
telephone service and support team. All other servicing should be performed by a certified service technician only.
Your warranty does not cover damage due to servicing that is not authorized by Riverbed. Read and follow the safety
instructions in the
Safety and Compliance Guide
.
Note:
For a list of supported NICs, see
Appendix A, “Supported SDI-2030 and SDI-5030 Gateway NICs.”
Important:
If your gateway is rack mounted, see
Appendix A, “Supported SDI-2030 and SDI-5030 Gateway NICs.”
to remove it from the rack before starting the procedures in this chapter.
Required tools
You need the following tools and equipment to replace gateway components:
•
An antistatic strap. When you replace gateway components, you must wear a grounded ESD
antistatic strap to protect the hardware against electrostatic discharge. Make sure that the strap
makes skin contact prior to handling equipment.