Riverbed SteelCentral AppResponse 2180, Руководство по модернизации и обслуживанию

Страница: 33 / 82

Replacing 2U xx80 and 9800 Components | 33
Replacing the disk drives
4. Release the air duct from the guide pins and then remove it from the chassis.
Figure 2-4. Removing the air duct
Replacing the disk drives
This 2section describes how to replace the hard disk drives (HDDs) and solid-state drives (SSDs) in 2U
xx80 and IC 9800 appliances. It includes these sections:
• “Before you begin” on page 33
• “Replacing HDDs in 2U appliances” on page 34
• “Replacing the rear SSDs in 2U appliances” on page 35
Before you begin
• When replacing a drive, replace only one drive at a time. You must use approved disk drives. To
order disk drives, contact Riverbed Support at https://support.riverbed.com.
• If you need to replace an appliance, you can’t move the disks to preserve your data. Each disk is
encoded with machine-level information and moving disks isn’t supported.
• When you replace disk drives, you must wear a grounded ESD antistatic strap to protect the
hardware against electrostatic discharge. Make sure that the strap makes skin contact prior to
handling equipment.
Caution: Always install the hard disk drive to the chassis after the chassis has been secured on the rack.