Quiana and Fandango 1.0 p 9
on, always check that a speaker is connected and that the power cord is firmly plugged
into the amp and the outlet.
Rear Panel
FUSE
F US
E
FUSE
F US
E
TO REDUCE THE RISK OF ELECTRIC
SHOCK,DO NOT REMOVE CHASSIS
REPLACE FUSE WITH SAME TYPE AND RATING
MAINS
INPUT POWER
300 WATTS
MAINS INPUT
FUSE
H.T.
FUSE
3A 250V
115V ~ 60Hz
SLO-BLO
500MA 250V
SLO-BLO
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
SERIAL NUMBER
VINTAGE / MODERN
MODEL
QUIANA/FANDANGO
RIVERA RESEARCH & DEVELOPMENT CORP., SYLMAR, CALIFORNIA, USA
LINE OUT
560
Ω
Z IN
250K
Ω
Z OUT
560
Ω
FOOTSWITCH
USE FS-7 ONLY
RETURN
RETURN
LEVEL
LEVEL
SEND
SEND
EFFECTS LOOP
TOTAL MIN. Z 8
Ω
55 W. RMS
SPEAKER JACKS IN PARALLEL
USE FIRST
CAUTION: CHASSIS SURFACE HOT
CAUTION: NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL
SPEAKER 1
SELECTOR
IMPEDANCE
SPEAKER 2
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
CAUTION
8
4
16
Mains Input
Your RIVERA amp has a detachable power cord that connects to the chassis AC
connector labeled Mains Input. Always use this cord and, in the event that the power
cord requires replacement, replace it with the same type of power cord. Consult your
RIVERA dealer for further information. Be sure to use a grounded electrical mains
power supply socket whenever possible. These outlets have a grounding pin in addition
to the normal line and neutral pin. The power cord supplied with your RIVERA amp has
a 3-pin plug. Do not cut off or damage the ground pin. If the available electrical outlet is
of the older 2-pin type, use a suitable ground-lift adapter.
The U.S.A., Canada, and Japan share a common CSA/UL-style cord. Most of Europe
and Scandinavia utilize a Euro plug and have a SEMKO/VDE-style cord. Australia uses
a different type of plug, as does England, and South Africa as well.
Note:
Avoid using long power extension cords. Long cords have sufficient resistance to
electrical current that the voltage arriving at your amp can be significantly reduced. This
can have a bad effect on your tone.
Mains Fuse (50Watt-55Watt Quiana and Fandango models)
This AC line fuse protects your amplifier from damage due to shorts, momentary
surges, and defective power tubes. In the event of a fuse failure, always replace it with
the same type of fuse.
Note:
Always turn the amp off and wait about five minutes before
replacing a fuse. This allows the parts to cool and high voltages to
dissipate.
For 100VAC versions, the Mains Fuse is:
3 Amp, 250 Volt Slo-Blo type (size 3AG, or MDL)
For 115VAC versions, the Mains Fuse is:
3 Amp, 250 Volt Slo-Blo type (size 3AG, or MDL)
For 230/250VAC versions, the Mains Fuse is:
T 1.6A (time-delay, 5mm x 20mm size)
