Quiana and Fandango 1.0 p 15
Driving two speaker cabinets
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
LINE OUT
560
Ω
TOTAL MIN. Z 8
Ω
55 W. RMS
SPEAKER JACKS IN PARALLEL
USE FIRST
SPEAKER 1
SPEAKER 2
8
Ω
8
Ω
In this configuration, the Quiana/Fandango is driving two speaker cabinets with identical
impedance's. Using heavy-gauge speaker cords, connect the output jacks labeled
Speaker 1 and Speaker 2 to the speaker inputs on extension cabinets with a minimum
8-ohm impedance and power-handling capacity of 60 watts (for 50W Quiana/Fandango
55). You can also hook up two 16-ohm cabinets, but avoid if possible the use of two 4-
ohm cabinets, because the overall impedance load will be below what is optimum for
the amplifier and sustained use could result in overheating damage. When using two 8-
ohm cabinets, set the Quiana/Fandango's Impedance Selector to 4 ohms. When using
two 16-ohm cabinets, set it to 8 ohms.
Running two amps in parallel without a Y-cord
HIGH
GAIN
GAIN
LOW
INPUTS
HIGH
GAIN
GAIN
LOW
INPUTS
FROM
GUITAR
The Preamp and output amp sections, as well as all controls, function normally in this
setup. Use a shielded cord. Note: Make sure speaker cabinets are connected to both
RIVERA amps.
