Harley-Davidson Tour-Pak Armrests
For All 1990 and newer FLT & FLH Models
Equipped with a Tour-Pak
#HD094
Unpack the armrests and familiarize yourself with the left and right side armrests
and their features as follows. The side of the black base or mounting plate with
the three slotted holes will be installed against the Tour-Pak, between it and the
speaker housings.
On models not equipped with rear speakers, holes will need to be drilled.
Notice that where the chrome hinge block of the arm bolts to the black base plate
there is an additional set of mounting holes to set the arms and pads 1” lower if
desired.
Note:
on the bottom of the chrome oval base there are several sets of mounting
holes. The pad can be removed and the oval reversed to be set farther out to the
side of the motorcycle and when removed, you will see there are two additional
sets of holes to move the pads and ovals farther forward or back on the arms to
suit your passenger.
Pivot Tension Adjustment:
Notice the hex or Allen screw at the bottom of the
chrome arm where it pivots. This is a locking set or “jam” screw. Remove this
screw which is only about 3/8” long. Above the screw just removed or deeper in
the hole, there is another screw which uses the same size Allen wrench. Tighten
this screw as required to get the proper tension or friction on the arms as desired
then replace and firmly snug the short locking or “jam” screw. This adjustment
can be made periodically to maintain the desired tension or resistance of the
arms swinging in and outward.
Cup Holder Bracket:
Note
- The silver angled “L” bracket supplied with the
#HD094 may be used to attach a cup holder to one of the armrest pad mounting
screws. There are unused holes on the bottom of the chromed oval base of the
armrest. The supplied bracket can be bolted to one of the holes by using one of
the shorter ¼ x 20 bolts that is in the cup holder hardware kit. We offer a chrome
cup holder (part # CH500) or a black leather wrapped version (part # CH600).
Other brands of cup holders may fit as well.
For all models equipped with rear speakers on the Tour-Pak.
The armrests attach by removing the speaker housings, placing the black base
plates of the armrests between the Tour-Pak and the speaker housings and
re-installing the speaker housings as follows.
1. Open the Tour-Pak lid and remove the inner liner, if so equipped, by
flexing it inward, away from the latches and bolts then lifting it up and out.
