RC Series
RC362HD-6211IR Installation Guide
04-2017-A
www.rivatech.de
8
Note
i
< Use of Ferrite Core >
Installing the ferrite core is highly recommended to reduce high frequency noise level.
Please follow the instructions below.
1. Open the ferrite core by lifting the clip.
2. Make one loop with the cable through the ferrite core.
3. Close the ferrite core to hold the cable loop into its place.
Note
i
< Attachment of Dome Cover – Alignment >
Make the two marks aligned to close the dome cover
by reference to the image on the right.
Caution
!
Do not forcefully pull or shake the dome cover as it is linked to the camera body with a
safety wire.
Micro SD
Fectory default
SD BOOT
1)
Place the installation template included in the
package on a desired installation surface.
2)
Drill two holes for the plastic anchors based on the
template paper, a bigger hole for the cable lines, and
insert the plastic anchors into the two drilled holes.
3)
Attach the provided gasket to the bottom of the
camera body for the prevention of water permeation.
4)
Detach the dome cover from the camera body by
loosening the three screws with the provided L wrench
(2.5mm).
5)
Insert the two provided O-rings to the screws
(M4x30) by reference to the image on the left.
6)
Install the provided ferrite core to the cable by
reference to the first note below.
7)
Take the camera to the installation surface, and
connect the LAN cable and the power cable dropped
from the ceiling to the corresponding connectors on
the camera.
8)
Align the screw holes on both sides of the camera
body with the plastic anchors on the installation
surface, insert the screws prepared at step 5 into the
screw holes on the camera body, and tighten them into
the plastic anchors with a screw driver.
9)
Adjust the angle of the camera. Refer to
4.2.
Adjusting angle of camera
for more details.
10)
Reattach the dome cover to the camera body by
aligning the alignment marks on both the dome cover
and the camera body. Refer to the second note below.
11)
Once properly aligned, tighten the screws into the
camera body with the provided L wrench for the firm
attachment of the dome cover. Then, remove the
protection film from the dome cover.
Micro SD
Fectory default
SD BOOT