12
www.rivatech.de
Analog Video Out Connection
Use a 75 ohm video coaxial cable to connect to a monitor’s analog video output and
check the camera’s connection and its image focus at the installation site. Be sure to
press the output configuration button (PAL/NTSC button), located on the left side of
the reset button to see the video. The factory default is ‘no video output’; Press once
to set the video to PAL, and press again to set the video to NTSC. Pressing the button
again will go back to ‘no video output’ mode, disabling the viewing through the analog
video connection.
The video output configuration must be set before you connect the
power cable. When changes get made while power cable is
connected, users must restart the device to reflect the change.
Once the PAL/NTSC button is pressed, the video display lasts for 3
minutes before it goes back to ‘no video output’ mode.
Users cannot adjust the video brightness while connected through
the analog video output. The brightness can be controlled only from
a Web browser.
Audio connection
The camera provides a mono audio input and output. Due to low audio output power,
an amplified speaker is recommended for enhanced sound. (Reframe from connecting
a headphone or earphone directly to the camera.)
Note
i
Note
i
