11
7.Operator checks the distance between the bottom
surface and seat frame, elevating the seat frame by
2~3 centimeters, release front wheel brake, slowly
moving the chairr from the seat;
8.Operator pushes the chair from the back to the
edge of the bed;
9.Check the seat frame height of the chair at the edge
of the bed to ensure that the bottom of the seat frame
is slightly higher than the bed surface (if the height of
the seat frame needs to be adjusted, the front wheel
must be locked before operation)
10.The operator completely pushed the chair to the
desired location of the bed, lock the front wheel by
brake, then adjust the height of the seat frame again,
so that the bottom of the seat frame slightly touched
the bed surface;
11.Release safety lock on the back of the chair,
slowly open the left and right seat frame, so that the
user can sit on the bed completely;
12.Operator release front wheel and lifts the user's
feet to remove the chair from the bed.
★
Note:
The foot control should be used with the limit control block.
When control block towards inside, keep on step on the foot control to uprising;
when on outside, the foot control keeps stepping to the bottom and controls the descent.