Rittal SK 3237 Series, Сборка и инструкция по эксплуатации

Страница: 10 / 21

6 Commissioning
10 Rittal fan-and-filter unit assembly and operating instructions
EN
6 Commissioning
• Once all the assembly and installation
work is complete, switch on the power
supply to the fan-and-filter unit.
The fan-and-filter unit operates automati-
cally, in other words, the fan will start up
once the power has been switched on.
6.1 Properties
– Four voltage variants are supported:
– 24 V DC
– 115 V, 1~
– 230 V, 1~
– 400/460 V, 3-phase
7 Changing the filter
7.1 Installing the filter media
The fan-and-filter unit and outlet filter are
supplied as standard with a standard filter
mat for the pre-filtering of dry, coarse dust
and lint. In order to increase the protection
category, and in the case of dust with a
grain size of < 10 µm, we recommend the
use of fine filter mats (optionally available).
Depending on the incidence of dust, you
will need to replace the filter mat from time
to time.
• Use your finger to pull the function logo
in the louvred grille upwards slightly to
unlock it. The grille will now flip open by
about 70° to allow the filter mat to be re-
placed easily.
Fig. 6: Release the louvred grille
• Insert the filter mat into the louvred grille
as shown in Fig. 7 and push the louvred
grille back onto the enclosure until it
snaps audibly into position.
Fig. 7: Install the filter mat
Caution!
Only change the filter mat
while the fan wheel is
stationary.
Never insert your fingers into
the fan wheel.
Note:
The progressive side of the filter
mat is pointing towards the fan
wheel.