Rittal 7999.009, Руководство по эксплуатации

Страница: 21 / 40

Rittal Micro Data Center Level E 21
7 Operation
EN
Pressing the P and 0 key combination deletes all pro-
grammed functions (secondary code, dual code, time
delay, opening window).
Closing

Turn the bar handle within 4 seconds clockwise until it
reaches the limit.
Function: Delegated dual-code mode
Activating/changing a dual code by the primary-
code holder

Open the lock with the valid 6-digit primary code (see
page 20).

Press the ON key.

Press the P key.

Enter the valid 6-digit primary code.
The
signal message appears.

Press the P key again.

Press the 5 key.

Enter the new 6-digit first subcode.
The
/ signal message appears twice.

Re-enter the new valid 6-digit first subcode.
The
signal message appears once.

Enter the new 6-digit second subcode.
The /
signal message appears twice.

Re-enter the new valid 6-digit second subcode.
The
signal message appears once.

Test the newly programmed secondary code by clos-
ing and reopening the lock.
If the first or second subcode was not confirmed cor-
rectly with the repeated input, the following signal mes-
sage appears three times
:

Repeat the action.
The sequence of the subcode and its repeated confir-
mation must be observed.
Opening
Opening with the primary code by the primary-
code holder

Press the ON key.

Enter the valid 6-digit primary code.
The
signal message appears once.

Turn the bar handle within 4 seconds clockwise until it
reaches the limit.
If the lock was last opened with the dual code, the fol-
lowing signal message occurs three times
:
.
Opening with the dual code by the dual-code hold-
er

Press the ON key.

Re-enter the valid 6-digit first subcode.
The
signal message appears once.

Enter the valid 6-digit second subcode.
The
signal message appears once.

Turn the bar handle within 4 seconds clockwise until it
reaches the limit.
If the lock was last opened with a primary code, the fol-
lowing signal message occurs three times
:
.
The sequence of the subcode must be observed. To
open the lock, the primary subcode and then the
secondary subcode must be entered.
Opening after three or more incorrect code inputs
Þ
penalty time
After three incorrect code inputs, the lock switches to a
1-minute penalty time. For each further incorrect code
input, the penalty time extends to 2, 4, 8 and maximum
16 minutes. During the penalty time, the red LED flashes
in second intervals and no further code input is possible.
The penalty time can be overridden with the inspection
key (see page 24).

After expiration of the penalty time, press the ON key
at any time.

Enter the valid 6-digit primary or secondary code.
The
signal message appears once.
The following message appears: An invalid code was
entered during a previous opening attempt. The signal
message also appears: three times

Turn the bar handle within 4 seconds clockwise until it
reaches the limit.
Changing the primary code by the primary-code
holder

Open the lock with the valid 6-digit primary code (see
page 21).

Press the ON key.

Press the P key.

Enter the valid 6-digit primary code.
The
signal message appears.

Enter the new 6-digit primary code.
The
/ signal message appears twice.

Re-enter the new valid 6-digit primary code.
The
signal message appears once.

Test the newly programmed primary code by closing
and reopening the lock.
If the new primary code was not confirmed correctly with
the repeated input, the following signal message ap-
pears three times
:

Repeat the action.